-
NodeMcu Wroom Esp32 Wifi Based Microcontroller Development Board
Original price was: ₨ 1,200.₨ 900Current price is: ₨ 900.
- Current receiving 80mA.
- the voltage supply is 2.2V to 3.6V.
- current transmitting is 80mA.
- The number of pins supported is 30.
- The data rate is 54Mbps.
- The frequency is 2.4GHz.
- Surface mount type.
- operating temperature is -40 to 85 degrees centigrade.
- power output is 16.5dBm.
- Integrated 520Kb SRAM.
- Ultra-low-power management.
- 4 Mb flash.
- On-board PCB antenna.
-
NOR Gate 7402 IC
Original price was: ₨ 80.₨ 45Current price is: ₨ 45.
The 7402 Quad 2-Input NOR Gate IC integrates four independent NOR gates into a single 14-pin DIP package. It’s ideal for logic control applications, digital circuits, and embedded systems needing negative-logic processing.
-
NOT Gate INVERTER 7404 IC
Original price was: ₨ 80.₨ 45Current price is: ₨ 45.
The 7404 IC is a hex inverter that contains six independent NOT gates in a single 14-pin DIP package. Designed for TTL logic operations, it’s widely used in digital signal inversion and control logic circuits.
-
Orignal Imported 2wd Smart Robot Car Chassis Kit
Original price was: ₨ 950.₨ 850Current price is: ₨ 850.
Voltage: DC 6V
Current: 120MA
Reduction rate: 48:1
RPM (With tire): 240
Tire Diameter: 66mm
Car Speed(M/minute): 48
Motor Weight (g): 50
Motor Size: 70mm*22mm*18mm
Noise: <65dB Tire Size
Tire Size Center hole: Long 5.3MM, 3.5MM
wide Diameter: 66MM
Width: 26MM
DC Gear Motor
No load speed (6V): 200RPM ±10%
No load current (6V): ≤200mA
No load speed (3V): 90RPM ±10%
No load current (3V): ≤150mA
Voltage: 3-6 V
Reduction ratio is 1:48 -
PASTE BROZA
Original price was: ₨ 100.₨ 30Current price is: ₨ 30.
PASTE BROZA is a versatile soldering flux paste designed to improve solder flow, reduce oxidation, and enhance joint strength. Ideal for PCB repair, wire soldering, and electronics assembly, it ensures clean and consistent results with minimal residue.
-
Photocell Street Light Sun Switch Sensor 12V
Original price was: ₨ 500.₨ 380Current price is: ₨ 380.
Upgrade outdoor automation with this 12V Photocell Sun Switch Sensor. Ideal for smart street lighting and solar projects. Operating voltage: 12V DC, load: up to 10A. Automatically turns lights ON at dusk and OFF at dawn—perfect for Arduino, IoT, and DIY lighting setups.
-
PIC16F887 Microcontroller
Original price was: ₨ 850.₨ 750Current price is: ₨ 750.
The PIC16F887 is a reliable 8-bit microcontroller with 14KB flash memory, 10-bit ADC, and up to 35 configurable I/O pins. It’s well-suited for automation, sensor-based applications, and embedded control systems where performance, cost-efficiency, and ease of programming matter.
-
PIC30F2010 28Pin 20MHz 16Bit In
Original price was: ₨ 1,100.₨ 890Current price is: ₨ 890.
The PIC30F2010 is a 16-bit dsPIC® digital signal controller (DSC) delivering up to 20 MIPS, housed in a 28-pin through‑hole package, featuring 12 KB Flash, 512 B RAM, 6-channel ADC, motor-control PWM, and encoder interface—optimized for industrial, control, and motor applications.
-
Pre Soldered Arduino Nano V3.0 With Cable in Pakistan
Original price was: ₨ 950.₨ 800Current price is: ₨ 800.
The Pre-Soldered Arduino Nano V3.0 (with USB Cable) is a compact, breadboard-friendly microcontroller based on the ATmega328P. Ideal for robotics and IoT.
-
Microcontroller: ATmega328P
-
USB Interface: Mini USB (Cable Included)
-
I/O Pins: 22 (14 Digital, 8 Analog)
-
Board Type: Nano V3.0 with pre-soldered headers
-
-
Pre Soldered ESP32 S3 WROOM 1 Development Board 2.4G Wifi BT Module BLE5.0
Original price was: ₨ 2,000.₨ 1,650Current price is: ₨ 1,650.
The ESP32-S3 WROOM-1 Pre-Soldered Development Board is a powerful WiFi + Bluetooth 5.0 BLE dual-core microcontroller designed for high-performance IoT, AI, and embedded projects. Featuring 2.4GHz WiFi, USB support, pre-soldered headers, and support for Arduino, MicroPython, and ESP-IDF, it’s ideal for smart devices, robotics, and wireless applications.
-
Operating Voltage: 3.3V
-
Dual-core 240MHz Tensilica LX7 CPU
-
Built-in 512KB SRAM, 384KB ROM
-
USB OTG, ADCs, GPIOs, PWM support
-
-
Precision Tweezers
Original price was: ₨ 270.₨ 200Current price is: ₨ 200.
The DT20 Perforated Tweezer is a high-precision, anti-static tweezer crafted from corrosion-resistant stainless steel. Featuring a curved fine-point tip and an ergonomic perforated handle, it is designed for accurate handling of tiny electronic components, especially during SMD soldering, circuit repairs, and delicate PCB work. Ideal for use with Arduino, Raspberry Pi, and other DIY electronics platforms, this tweezer ensures both control and safety in high-precision environments.
-
Prototype Shield for Arduino UNO
Original price was: ₨ 280.₨ 245Current price is: ₨ 245.
The Prototype Shield for Arduino UNO is a solderable expansion board designed to help you build and test custom circuits. It includes a mini breadboard, reset button, power lines, and access to all Arduino pins, making it perfect for rapid prototyping and circuit development.
