User
0
0

Showing 1–12 of 38 results

  • 100% Copper 12V DC Motor For Air Cooler & Stand Fan Original Baleno High Speed in Pakistan

    Original price was: ₨ 2,000.Current price is: ₨ 1,500.

    100% Original Copper Winding Baleno 12v Dc Motor Low noise, high speed, high efficiency, low resistance. Widely use for Air Cooler, Stand fans, Wall Fan, Pedestal Fan, And Table Fan. Solar Motor For Special Projects 2800-3000 RPM.

  • 16 Channel Servo Motor Driver Pca9685 12 Bit Pwm I2c Module For Arduino

    Original price was: ₨ 1,000.Current price is: ₨ 750.

    This  16-Channel 12-Bit Servo motor driver empowers your robotics and automation projects with unparalleled control. Effortlessly manage up to 16 servos simultaneously using just 2 I2C pins on your microcontroller, freeing up valuable GPIO resources.

  • 2000w 25a Ac50-220v Adjustable Ac Dimmer Ac Heater Controller in Pakistan

    Original price was: ₨ 500.Current price is: ₨ 400.

    • The voltage is 50-220V.
    • The current is 25A.
    • Power is 2000W
    • Its Size is 52*47*27mm/2*1.85*1in Operation
    • Environment Temperature is between -20℃-40℃

  • 5V DC Gear Motor for Smart Car Robot in Pakistan

    Original price was: ₨ 150.Current price is: ₨ 130.

    Operating voltage: 3V ~ 6V DC

    Maximum torque: 800gf cm min (3V time)

    Reduction Ratio: 1:48 (3V time)

    Rotate Speed: 125rpm/min

    Tire Diameter: about 66mm

    Tire Thickness: about 28mm

    Load Current: 70mA (250mA MAX) (3V time)

    This motor plus EMC, anti-interference ability. Microcontroller without interference

     

  • 6 Volt DC Metal Gear Motor In Pakistan.

    Original price was: ₨ 700.Current price is: ₨ 500.

    • High-Power DC Gearmotor
    • Nominal Voltage: 6V
    • No Load RPM: 97
    • Stall Current: 6.5A
    • Stall Torque: 210 oz-in
    • Shaft Diameter: 4 mm

  • A4988 Stepper Motor Driver in Pakistan A4988 Stepper Motor Driver in Pakistan

    Original price was: ₨ 300.Current price is: ₨ 280.

    • its supply voltage is 8 to 35V DC.
    • it has 1A current without a heatsink.
    • it gives 2 A current with the heat sink.
    • 3 to 5.5V is logical input.

  • BO Robot Smart Car Wheel Tyre in Pakistan

    Original price was: ₨ 150.Current price is: ₨ 100.

    Specification of 68mm RC car tire:

    • – Diameter:68mm
    • – Width:26mm
    • – Other size refer to below picture
    • – Weight:40g/pc

  • CNC USB MACH3 100Khz Breakout Board 4 Axis Interface Driver Motion Controller

    Original price was: ₨ 3,000.Current price is: ₨ 2,600.

    his 4 Axis CNC USB Controller is designed to be used for notebook and tablets simple configuration and compatibility. The card can run what all other MACH 3 controllers can run and supports the drive shaft and the driven shaft gantry supports automatic leveling and has an output pulse 100 KHz.

  • DC Motor 2RPM Reverse High Torque Turbo Worm 1 Gear Motor in Pakistan

    Original price was: ₨ 4,500.Current price is: ₨ 3,500.

    • Voltage: DC12V
    • Load torque: 10KG.CM
    • Non-load speed selection: 2rpm / 3rpm / 10rpm / 30rpm / 100rpm
    • Suitable for: Widely used in windows, door opener, mini winch, and other occasions

  • dc-5v-4-phase-5-wire-stepper-motor-with-uln200 28YBJ-48 DC 5V 4 Phase 5 Wire Stepper Motor With ULN2003 Drive in Pakistan

    Original price was: ₨ 400.Current price is: ₨ 290.

    28YBJ-48 DC 5V 4 Phase 5 Wire Stepper Motor With ULN2003 Driver BoardDescription:This is 28YBJ-48 DC 5V 4 phase 5 wire stepper motor with ULN2003 driver board5-wire phase can drive ordinary uln2003 chip can also be connected as phase 2 may be supporting the development board, direct plug. Motor:Diameter: 28mmVoltage: 5VStep angle: 5.625 x 1/64Reduction ratio: 1/64ULN2003 driver board:A, B, C, D LED indication Four-phase stepper motor work statusSize: 31x35mmPackage included:1 x ULN2003 driver board1 x 28BYJ-48 stepper motor Options:5WireStepperMotor

  • DIY Robotic Arm 5 degrees of freedom 5DOF Without Motor

    Original price was: ₨ 10,000.Current price is: ₨ 7,500.

    DIY Robotic Arm 5 Degrees of Freedom (5DOF) Without Motor – This is a 5DOF robotic arm kit designed for DIY enthusiasts and robotics projects. It allows you to build a versatile arm with 5 independent movements, perfect for learning and experimentation. Motors are not included, giving you the flexibility to choose the power source and motors that suit your project. Ideal for educational purposes and building customized robotic systems

  • DRV8825 Stepper Motor Driver With Aluminum Heat Sink

    Original price was: ₨ 550.Current price is: ₨ 450.

    DRV8825 Stepper Motor Driver with Aluminum Heat Sink – High-performance stepper motor driver supporting up to 45V and 2.5A per coil with microstepping (up to 1/32). Compatible with Arduino, CNC, and 3D printer applications. Comes with a heat sink for better cooling.

    Pin Description:

    • VMOT – Motor power supply (8.2V-45V)
    • GND – Ground
    • VCC – Logic power (3.3V-5V)
    • DIR – Direction control
    • STEP – Step pulse input
    • ENABLE – Enable/disable driver
    • MS1, MS2, MS3 – Microstep selection
    • FAULT – Error indicator
    • RESET – Reset driver
    • SLEEP – Low-power mode

Filter by price

0
    0
    Your Cart
    Your cart is emptyReturn to Shop
    Continue Shopping